Coursemaster CM80i 12V Autopilot for Power Boats with Hydraulic Steering - Suits Boats with Outboard Motors 5-10M - Easy Installation (CM80i)
Coursemaster CM80i 12V Autopilot for Power Boats with Hydraulic Steering - Suits Boats with Outboard Motors 5-10M - Easy Installation (CM80i)
-
Online Price: $0.00 (including 10 % GST tax)
- OR -
Australia's Best Price on Coursemaster CM80i 12V Autopilot for Power Boats with Hydraulic Steering
Suits Boats fitted with Outboard Motors 5-10M - Easy Installation (CM80i)
overview
Coursemaster CM80i 12V Autopilot for Power Boats with Hydraulic Steering
Suits Boats fitted with Outboard Motors 5-10M - Easy Installation
CM80i now discontinued
See
Coursemaster CM82i 12V Autopilot for Power Boats with Hydraulic Steering - Suits Boats with Outboards, Stern Drive or Inboard Motors 5-10m (CM82i)
The Coursemaster CM80i breaks new ground in intelligent autopilots. The new features of this system makes it both easier to install and very easy to use. The intelligence built into the system means that there is no need for a rudder transducer, and the system adjusts itself to suit the boat speed and state of the sea. The Coursemaster CM80i's compact design fits easily into almost any small boat dash and also closely matches engine instruments for great aesthetics.
Installation can be completed easily and once installed, requires a simple, once only set up procedure which takes less than a minute. The CM80i's main components are:
- Control head
- Junction box
- Rate Gyro Compass
- Hydraulic pump
- The CM80i interfaces with GPS, has a heading output for use with radar, and includes a rate gyro compass.
Downloads:
specification
SPECIFICATIONS CM80i
CM80i Autopilot System
CM80i AUTOPILOT SYSTEM
ENVIRONMENTAL: 0 - 50 degC
STEERING SYSTEM TYPES: Hydraulic
POWER CONSUMPTION: Standby: 300mAmps @ 12VDC
Pilot - 2.5amps @ 20% duty cycle using standard hydraulic pump
CM80i CONTROLLER
DISPLAY: Backlit LCD dot matrix
ALARMS: Off course, watch keeping, system
DIMENSIONS: 95mm x 55mm
MOUNTING: panel mount, bracket mount
CABLE: 4m
CM840 JUNCTION BOX
INPUT VOLTAGE: 12VDC
MOTOR DRIVE: 15Amp cont
HEADING SENSOR: Rate Gyro compass
INTERFACE: NMEA 0183, 2 x input, 1 x output
DIMENSIONS: 205mm x 140mm x 45mm
CM437 RATE GYRO COMPASS
ACCURACY: 2degrees RMS
ROLL/PITCH: +/- 35 degrees
DIMENSIONS: 95mm x 55mm
CABLE: 8m
HYDRAULIC DRIVE
CMPRO612
VOLTAGE: 12VDC
TYPE: Reversing
CAPACITY: 0.6L/min