Muir Prices
AV
Lighting
B-TECH LITHIUM PACKAGES
Refrigeration
Rule Pumps
Hella Navigation Lights
Lonestar
Battery
ICOM
Smart TV
Pumps
Muir Winches
Hot Water Heaters
Plastimo Compass
BBQ_2
Isotemp Hot Water System
Solar
Battery Chargers
TV
Topargee
Electrical
Clarion
Jabsco Pumps
B-Tec Lithium
Bennett
BBQ
Majestic
Aus Wide Shipping

ICOM IC-AT141 Auto Antenna Tuner for Icom GM800 HF Radio (IC-AT141)

  • Icom
    • ICOM IC-AT141 Auto Antenna Tuner for Icom GM800 HF Radio (IC-AT141)

    ICOM IC-AT141 Auto Antenna Tuner for Icom GM800 HF Radio (IC-AT141)

    ICOM IC-AT141 Auto Antenna Tuner - Frequency Range 100 kHz-30 MHz
    • $950.00
    • $827.00


    - OR -

    AT-141 AUTOMATIC ANTENNA TUNER Matches the transceiver to a long wire antenna with little insertion loss. Antenna and control cable receptacles are easy to install.

    overview

    ICOM IC-AT141 Auto Antenna Tuner for Icom GM800 HF Radio (IC-AT141)

    Full automatic tuning  – Just push the [TUNE] switch on the transceiver, and the AT-141 adjusts immediately to the minimum SWR of any frequency on any HF marine band.

    HF operation on any size ship – The AT-141 allows you HF operation where antenna element length is restricted due to space.

    Weather resistant – The AT-141 is housed in a durable, completely weather resistant ASA case with a rubber gasket. The antenna tuner can be conveniently installed both on the deck or in the cabin near the antenna element.

    Simple installation – Installation is simple. Just connect the control and antenna cables. You never need to open the cover. 45 memories for shorter tuning time To decrease the tune-up time, the AT-141 automatically stores the matching conditions for up to 45 frequencies.

    Re-tuning for a memorized frequency takes approx. 1sec.

    Super capacitor for memory backup – Even if the AT-141 is not used for approx. 1 week, the built-in super capacitor backs up contents of the 45 memories.

    Low power tune up – The AT-141 emits low output power during tuning. This feature reduces the possibility of causing interference to other stations.

    Tuner through function – The tuner through function is built into the AT-141. This function helps improve receiver gain, depending on the antenna element length used, and operating frequency

     

    specification

     

    Frequency coverage 1.6–30 MHz (with 7 m or longer antenna element)
    Power supply requirement 13.6 V DC (supplied from the HF transceiver)
    Current drain Maximum 2 A
    Operating temperature range –20°C to +55°C
    Weight (approximately) 2.5 kg
    Antenna connector SO-239 (50 Ω)
    Maximum Input power 150 W (PEP) 100 W (continuous)
    Automatic tuning time Approximately 2 to 3 seconds (general condition)
    Maximum 15 seconds
    Automatic tuning accuracy SWR 2.0:1 (after tuning, except for multiples of 1⁄2 λ)
    Usable pole diameter 32 to 60 mm
    IP rating IPX4
    Note Version 45 must be used for MED certification compliance with the GM800.

    All stated specifications are subject to change without notice or obligation